911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Removing Old Sealant
In case of repairs, the old sealant coat must not necessarily be removed. It is sufficient to de-grease the surface and apply the new coat of sealant after
the solvent has evaporated.
New Loctite will soften the old sealant embedded in the machining marks and will cure after assembly.
Should it be required to remove the old sealant, it is recommended to use a fine-mesh wire brush or Loctite adhesive remover 80646.
Applying Sealant
1. For manual application, it is recommended to use a short-pile paint roller and to pour the sealant into a dish with grooves at its circumference (for
squeezing excess sealant off the roller).
2. Apply a uniform coat of Loctite 574 to the sealing face of the camshaft housing by using the paint roller. Use a small paint brush to apply sealant
to the straight pins around the bolt holes.
