911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
9. Disconnect pressure hoses from turbocharger (compressor side). Seal turbocharger immediately.
10. Loosen two pan head screws (M6 x 12) on the right-hand, lateral engine paneling (accessible from top).
11. Drain oil at turbocharger/oil tray.
12. Loosen oil return line between turbocharger/oil tray and bracket. Loosen bleeding line between turbocharger/oil tray and upper intake pipe.
13. Remove intake hose between turbocharger and intake pipe.
WARNING: (Risk of Injury!). Do not use a screw driver as a lever to disconnect the hose as the vacuum control unit might get damaged!
14. Cut the control hose right behind the vacuum control unit fitting. Use a sharp knife to open the remaining hose.
15. Loosen pan head screws (M8 x 18) between turbocharger bracket and cam- shaft housing.
16. Loosen turbocharger mounting point (combination screw M8 x 16).
17. Remove hoses between heat exchanger and heating flap box.
18. Loosen fastening nuts (M8) of heat exchanger and remove heat exchanger and turbocharger.
NOTE: Two persons are required to detach and remove the turbocharger/heat exchanger assembly.
19. Remove heat exchanger from turbocharger.