911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
NOTE: the installation position for part A of special tool 9512. The hole for the fan wheel shaft is out of center (2 mm).
11. Push part B into the cutouts.
12. Tighten wing screw (part C) until the blower motor disengages.
13. Pull off connecting wire.
Left-hand blower
14. Detach reservoir from tank.
15. Pull wire off the housing cover. Screw out knurled nut and use a screwdriver to detach retaining clamp from housing cover. Take off housing cover
from above.
16. For further steps, proceed as per items 9 to 13 above.
NOTE: When installing the motor, make sure the blower motor engages correctly and the connection wires are not squeezed.
Check if the blower wheel rotates freely.