911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Air Bag: Service and Repair
Removing and Installing Driver Airbag Unit
1. Disconnect battery and cover terminals --or entire battery.
2. Undo fastening screws (2 ea.) with a Torx T-30 socket screwdriver.
3. Pull off connector.
NOTE: Replace the self-locking nuts whenever they have been released, undoing the retaining plate of the airbag unit (4 screws) in the steering
wheel.
WARNING: When stowing away the airbag unit, make sure the padded side faces up. The airbag unit must be stored in a safe place
when it remains removed for longer periods. Observe safety precautions.
-
Tightening torque for fastening screws (two M 6x16 screws): 10 Nm (7 ft.lb.)
-
Tightening torque for retaining plate (four M 5x20 screws): 5 Nm (3.5 ft.lb.)