911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
2. Refit the steering wheel with the front wheels in the straight-ahead position or in accordance with the marking so that the upper spokes of the
steering wheel are horizontal.
-
Important: Do not trap the cable of the contact unit.
-
Fit hexagon nut with spring washer and tighten to 45 Nm (33 ft lb).
3. Fit plug of the ignition switch and buzzer contact.
4. On key lock vehicles, screw in the cable in ignition steering lock position "II".
-
Then select position "P" and subsequently turn ignition steering lock to position "0".
NOTE: If the ignition steering lock cannot be turned to position "0", the cable adjustment must be corrected (refer to Transmission and
Drivetrain).
5. Perform function test on the ignition steering lock (locking pin function) and key lock function test.
-
Only once this is in order, tighten the shear bolts in the sequence below until they shear off.
- No. 12 (on the steering outer tube)
- No. 14 (on the dashboard).
6. Install the Central Information System, the knee protector strip, the heating and fresh air regulator and the side vents.
7. Install driver's airbag unit.
-
Use new fastening screws.
-
Tightening torque: 10 Nm (7.5 ft lb).
8. Connect battery and check function of electrical system.
