911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
-
Before you install the second bead, the fitting arm should be opposite the valve.
Then place the second bead as flat as possible on the wheel, guide it over the fitting head and hold it in place using special tool 9539 at an
angle of 90 - 120°.
-
During the turning and installation of the second bead, a second tire lever and special tool 9539 must be held against the tire bead in the well.
NOTE: Depending on the wheel/tire combination, it may be necessary to apply the additional tire lever below the hump.
-
When the tire is filled, the beads must cross the hump at a pressure of no more than 3.75 bar gage
If necessary, repeat lubricant application.
Tire Removal
-
Set fitting head as for tire fitting (as shown in illustration above.
-
Press tire off at both sides.
-
Apply tire lubricant to tire and wheel flange.
Tire Removal (Part 1 Of 2)
