911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Seals and Gaskets: Service and Repair
NOTE: The seals may also be replaced with the front axle final drive remaining installed.
Removal
1. Remove halfshaft flange by placing a chisel or spacer "A" below the halfshaft flange and turning bolt "B" to pull out halfshaft flange.
-
In case the halfshaft flange is tilted, screw another bolt into the opposite hole.
2. Lever out seal with a suitable tool.
Installation
1. Pack space between dust and grease lips with grease (e.g. Liqui Moly Pu 53) and drive seal home to stop, using Special Tool 9537.
2. The snap ring of the halfshaft flange must always be replaced.
-
Use protective jaws to mount flange in a vise and press out snap ring with a new snap ring "A".
3. Grease snap ring liberally and press in halfshaft flange with a suitable drift.