911 Turbo AWD (996) F6-3.6L Turbo (2001)
Accessory Control Display: Service and Repair
Removing and Installing Display and Operator Control Unit (PCM 2), - As of My 2003
Removing And Installing Display And Operator Control Unit (PCM 2), - As Of MY 2003
Removing display and operator control unit (PCM 2)
NOTE:
-
If the PCM is replaced by a new or a different PCM, read out the data with the Porsche System Tester before removal.
-
The PCM has an optical waveguide (LWL). Information on the optical waveguide (LWL):
1. Unclip switch cover from below using a plastic spatula and disconnect electrical plug connections.
2. Insert a hexagon-socket wrench sideways into the screw connection of the PCM detent hooks.
3. Close the detents (2 each side) with the hexagon-socket wrench -A- and carefully pull out the PCM.
4. For reinstallation, open the detents with the hexagon-socket wrench -B-.
NOTE:
-
The number of plug connections will vary, depending on the I No. (CD changer, Bose, amplifier).
-
The variant without additional audio components (external Most control units) has a jumper (output to input) connected to the optical
waveguide plug.
5. Unlock and pull off antenna plugs -A, E, F-.
6. Unlock and disconnect the electrical plug connections in the order -C, B, D-.