911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
5. Removing seals and retaining bracket at sides of roof frame
The seal on the roof frame consists of two parts.
a. Pull the lower seal -5- out of the profile of the retaining strip -7- .
b. On the upper seal -6- with the retaining rail -7-,
unscrew the Torx screws T15 -8- and remove the seal -6- and the retaining rail -7- from the roof frame.
6. Removing retaining rail and convertible-top seal on roof frame 1
a. Unscrew and remove the Torx screws T25 -9- from the retaining rail -10-
b. Unscrew the Torx screw T25 -11- from the convertible top seal -12-.
c. Pull left and right convertible top seal -12- out of the roof frame 1 towards the front in -direction of arrow-.
7. Removing convertible-top covering at sides of roof frame 1
Unscrew the fastening screws -13- from the roof frame -15-, lift the shaped sheetmetal part -14- with convertible-top covering.
8. Removing convertible-top covering at front on roof frame 1.
Detach the convertible-top covering at front on roof frame 1 and lay it down to the rear in -direction of arrow-.