911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
INFORMATION:
-
Before replacing, check the existing seal for signs of damage (areas torn, crushed, etc.). If there are signs of damage, the seal must be replaced.
-
The seal is pressed onto the flange without any additional sealants.
1. Position the seal -1- from above -A-.
Installing front lid seal
INFORMATION: Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
1. Pre-position the seal -1- and press onto the sheetmetal flanges in this area -A-.
2. Apply the seal evenly along the flange. Position and press the seal without any tension on the flanges to the wing -B-, to the closing panel -C- and
to the radiator tank cover -D-.
3. Check whether the installation is correct.