911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Scuff Plate: Service and Repair
Removing and Installing Cover For Front Lock Mount
Removing And Installing Cover For Front Lock Mount
Removing cover for lock support
1. Open front lid.
2. Loosen cover for lock support -1- at the Velcro fasteners -2-.
3. Actuate lid-release lever -3- in -direction of arrow A- and remove cover for lock support -1- (-arrow B-).
4. Lift cover for lock support up slightly -1-, release the locking tab at the side from below -arrow A- and pull it out of the cover for the wing flange
-2- (-arrows B-).
Installing cover for front lock mount
Installing cover for lock support
INFORMATION: The Velcro fasteners must be removed and replaced when replacing the front apron and cover for lock support.
1. Check Velcro fasteners on front apron and cover for lock support and replace if necessary. See: Additional assembly instructions for replacing
Velcro fasteners
2. Insert trim panel for lock support -1- sideways into the cover for the wing flange -2- (-arrows A-).
3. Actuate lid-release lever -3- in -direction of arrow A- and fit trim panel for lock support -1- (-arrow B-).