911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Installing convertible-top peg mount
1. Place convertible-top peg mount -1- on windscreen frame from below -arrow A-, position it correctly and screw down hand-tight using the
fastening screws -2-.
2. To position convertible-top peg mount, close convertible top or fit hardtop.
3. Move convertible-top peg mount as far as possible outwards (towards the centring journal) -arrow B- and screw down. Tightening torque: 10 Nm
(7.5 ftlb.)
4. Position cap -3- from below -arrow C- and clip into place.
Subsequent work
1. Install sun visor. Refer to Removing and installing sun visor.
2. End service position. Refer to Convertible top service position.
3. Check gap dimensions for convertible top, adjust if necessary. Refer to Diagram - body gap dimensions
INFORMATION: Only for vehicles with hardtop.