911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Place convertible-top peg mount -1- on windscreen frame from below -arrow A-, position it correctly and screw down hand-tight using the
fastening screws -2-.
2. To position convertible-top peg mount, close convertible top or fit hardtop.
3. Move convertible-top peg mount as far as possible outwards (towards the centring journal) -arrow B- and screw down. Tightening torque: 10 Nm
(7.5 ftlb.)
4. Position cap -3- from below -arrow C- and clip into place.
Subsequent work
1. End service position. Refer to Convertible top in service position
2. Check gap dimensions for convertible top, adjust if necessary.
INFORMATION: Only for vehicles with hardtop.
3. Install hardtop. Refer to Removing and installing hardtop.
INFORMATION: Only for vehicles with hardtop.
4. Adjust hardtop. Refer to Adjusting hardtop.
Subsequent work
INFORMATION: Only for removing/installing or replacing convertible-top peg mount.
1. Install sun visor. Refer to Removing and installing rear window.