911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Unscrew fastening screws -2- inside and remove the retaining angle -3-.
3. Unscrew fastening screws -2- outside and remove bracket for hardtop mount -4- upwards out of the frame of roll-over protection system -5-.
Installing hardtop fastening
Installing bracket for hardtop mount
1. Position bracket for hardtop mount -4- on frame for roll-over protection system -5- and screw down the fastening screws -2- on the outside.
Tightening torque: 9.7 Nm (7.2 ftlb.)
2. Position retaining angle -3- on frame for roll-over protection system -5- and screw down with the fastening screws -2- on the inside. Tightening
torque: 9.7 Nm (7.2 ftlb.)
INFORMATION: Only when removing the left bracket for hardtop mount.