911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
4. Release plug connection -3- -arrow a- and disconnect -arrows B-.
5. Pull off the white hose -4- from the air cushion control valve -arrow C- and remove the air cushion motor -2-.
Installing air cushion motor
1. Position air cushion motor -2- and push on the white hose -4- onto the air cushion control valve -arrow A-.
2. Push the plug connection -3- together -arrows B- until it is felt to engage.
INFORMATION:
-
Observe hose routing.
-
Ensure that no hoses are disconnected by the tie-wraps.
3. Secure air cushion motor -2- onto support using two new tie-wraps -1-.
4. Position support -2- with connected motor and air cushion control valve and screw down with the two fastening screws -1-.
Subsequent work
Install front seat. Refer to Removing and installing front seat.