911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
4. Take motor for lumbar support -2- out of the backrest frame ( -arrow C- ) and pull the hose -3- along with the motor out of the backrest frame
-arrow D-.
Installing motor for lumbar support
1. Push hose -3- into the backrest frame -arrow A- and insert motor for lumbar support -2- into the backrest frame -arrow B-.
2. Push plug connection -1- together -arrows C- until it engages securely.
3. Lay the white hose -1- on the backrest frame -2-.
4. Push the white hose -1- onto the control valve for lumbar support -2-.
Checking seat following removal
1. Connect the removed seat to the vehicle's wiring harness via test cable 9745 and test cable 9745/1.
2. Connect electric plug to control module trim panel. Refer to Removing and installing control module trim panel.
3. Connect the battery. Refer to IN -Work instructions after disconnecting the battery
4. Switch on ignition.
5. Carry out a function check on the seat components.
6. Switch off ignition after function test and disconnect battery.
7. Disconnect test cable 9745 and test cable 9745/1.
Fitting foam part