911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Installing motor for rear vertical adjustment
1. Insert the drive shaft -1- into the gear mount -2- by twisting slightly.
2. Push motor for rear vertical adjustment -3- onto the drive shaft by twisting slightly and secure with the two fastening screws -2-. Tightening
torque: 7 Nm (5 ftlb.)
3. Attach connector -1- to motor for rear vertical adjustment -3- until it engages firmly.
Subsequent work
Install front seat. Refer to Removing and installing front seat.
Removing and Installing Motor For Seat Adjustment
Removing And Installing Motor For Seat Adjustment
Preliminary work
Remove front seat. Refer to Removing and installing front seat.
Removing motor for seat adjustment