911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
INFORMATION:
-
The rubber seal for the door must be fitted by hand.
-
Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
-
Check the air vents; they must not be closed or covered.
1. Push rubber seal for door -1- all around the sheetmetal flange.
2. Push rubber seal for door -1- under the cover strip -3- -Arrow A- and screw down with the fastening screw -2-. Tightening torque: 6 Nm (4.5 ftlb.)
Installing cover of three-point seat belt
1. Check clamps -2- for damage, replacing if necessary. Press in cover of three-point seat belt -1- into the clamps with the locking tabs until these
lock with an audible click.
Subsequent work
1. Install inner sill. Refer to Removing and installing inner sill.
2. Install A-pillar trim. Refer to Removing and installing A-pillar trim.