911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Brake-piston damping plates no longer used
4. Install expanding spring. Center the retaining pin in the bore using the M8 auxiliary screw. To do this, push the retaining pin back with the
auxiliary screw and then push the retaining pin through. Remove auxiliary screw and tighten new fastening screw at the retaining pin to 30 Nm (22
ftlb.).
5. Fit warning contact wire on the disc brake pads, expanding spring and brake calliper -arrows-.
6. Position disc brake pads by operating the brake several times.
7. Check the brake fluid level and correct it if necessary. The brake fluid level must be between the MIN/MAX marking.