911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Brake piston resetting fixture
3. Insert new damping plates into the pistons.
Always remove the protective film on the damping plates before installation.
Damping plates in brake pistons
When fitting the damping-plates on the small pistons, position the cut-out on the damping plate -Arrow- at the brake-pad guide pin because
otherwise the damping plate will be deformed.
Damping plate at guide pin
4. Install new disc brake pads.
5. Fit expanding spring. Center the retaining pin in the bore using the M8 auxiliary screw. To do this, push the retaining pin back with the auxiliary
screw and then push the retaining pin through. Remove auxiliary screw and tighten new fastening screw at the retaining pin to 30 Nm (22 ftlb.).