911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Bellows
2. Connect the push rods. Use a new lock nut -Arrow- to do this.
Push rod mount
Information
Adjusting the brake push-rod length changes the position of the brake pedal.
If the brake pedal is not at the correct position, the brake push rod must be adjusted slightly.
Check the brake light switch setting.
3. Check the position of the brake pedal and adjust it if necessary (Dimension X = 48 +2 mm). Measure between the brake pedal plate and the
accelerator pedal.
Fine adjustment for brake push rod (Dimension X = 48 +2 mm): Undo the lock nut -1- and turn the push rod as required at the hexagon -2-, then
set the dimension -X-. Tighten the lock nut.
Brake pedal position