911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Vacuum line connections
Vacuum line at tandem pump
3. Raise the lifting platform. Fit vacuum line correctly at the tandem pump. Replace the two micro-encapsulated (self-locking) fastening screws -5
and 6- whenever they have been loosened.
5 - Short M6 x 10 Torx screw (blue)
6 - Long M6 x 16 Torx screw (red)
3.1.
Pull protection cap off the new vacuum line. Coat O-ring lightly with engine oil and insert new vacuum line -1- into the tandem pump. Caution:
Risk of damaging O-rings!
3.2.
Screw in new micro-encapsulated (self-locking) fastening screws -5 and 6- and tighten to 10 Nm (7.5 ftlb.). Counter at the hexagon on the
combination screw behind it (behind the holder) when tightening the Torx screw -5-. You only need to counter if a combination screw is fitted
under the holder (introduced only in the current model series). Observe position (fastening point) for short screw -5- and long screw -6-.
4. Secure vacuum line -1- to the combination holder -3-.
Clip line into the retaining clip -4-
Vacuum line connections
Subsequent work