911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Screws on power-steering pump pulley
5. Turn the belt tensioner clockwise as far as it will go -Arrow- and at the same time place the drive belt over the deflection roller under the
generator.
Drive belt tensioning roller
6. Allow the belt tensioner to slide back slowly into tensioning position.
7. Tighten the outer Torx screws (M8 x 12) on the pulley. - Tightening torque: 23 Nm (17 ftlb.)
Information
It is absolutely necessary to check that the drive belt is correctly seated on all pulleys.
8. Check belt routing and position.
Subsequent Work
1. Install air cleaner housing.