911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
8. Remove hydraulic pump with reservoir.
Removing belt tensioner
Warning
Coolant is hazardous to health.
Risk of skin irritation.
-
Wear protective gloves and goggles.
-
In the event of contact with the skin or eyes, wash immediately with plenty of water.
1. Remove unit carrier.
1.1.
Remove coolant flange -5-.
Unit carrier
Unscrew M6 screw -4- on cable rail.
Unscrew M6 x 20 screws -3- and take off coolant flange.
1.2.
Unscrew four M10 x 60 screws -1- and remove unit carrier -2-.
2. Remove belt tensioner.
Belt tensioner
Unscrew M6 x 16 screw -3- and two M8 x 16 screws -2- and pull belt tensioner -1- off the tensioning lever.
Installing belt tensioner
1. Install belt tensioner.
Slide belt tensioner -1- onto the tensioning lever. Fit and tighten two M8 screws -2- and one M6 screw -3-.