911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
12. Slide oil pressure line -1- past the turbocharger holder and then guide it out in an upward direction from the engine compartment side.
13. Replace the O-rings on all lines and clean the connections.
CAUTION:
Risk of dirt getting into turbocharger bores.
-
Risk of damage to turbochargers.
-
Carefully clean connection bores.
-
Do not use compressed air as this can block the lubrication bores.
14. Make sure to check the connection bores on the turbocharger for dirt and clean them if necessary.
Removing oil pressure line - cylinder bank 4-6
1. Remove cover plate. Unscrew two M6 Torx screws and take off cover plate.
2. Loosen holding clamp -2- for oil pressure line -1- on the camshaft housing cover. Unscrew one M6 Torx screw.
2.1. Disconnect ignition coil plug for cylinders 4 and 5 -3-.
2.2. Disconnect cable plug for hall sender -4-.
3. Remove ignition coil for cylinder 5. Unscrew two internal M6 Torx screws and pull off ignition coil.
4. Loosen oil pressure line -1- on cylinder head 4-6.