911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Slide the rubber sleeve from the special tool stopper 9264/6 onto the throttle body and secure in place with the original screw-type clamp.
2. Slide the stopper -1- into the rubber sleeve and tighten the screw-type clamp as required.
3. Build up overpressure of 0.5 bar. Larger leaks are very easy to hear once the pressure has built up; smaller leaks can be made visible using
leak-locating spray.
4. Remove special tool stopper 9264/6.
5. Carry out the required repair work to seal any leaks you find.
Subsequent work
1. Fit original rubber sleeve on the throttle body. Tighten screw-type clamp.
Tightening torque: 2.5 Nm (2.0 ftlb.)
2. Fit pressure pipe -1-.