911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1.1. Clean sealing surfaces on the intake-air distributor and crankcase.
1.2. Replace the seals in the intake-air distributor and insert into the grooves
1.3. Introduce right intake-air distributor, twist slightly and insert, fit and tighten screws.
Use 6 mm screwdriver insert with ball joint for screws that are difficult to reach.
Tightening torque: 10 Nm (7.5 ftlb.)
CAUTION:
Low load capacity of pipe and line connections.
-
Damage and leaks at pipe and line connections.
-
Always counter at the lines when loosening and fastening them.
2. Install fuel collection pipe with fuel injectors 4-6.
2.1. Replace O-rings of the fuel injectors.
2.2. Clean sealing faces with a clean, lint-free cloth. Apply a thin coat of silicone spray to the O-rings.
2.3. Insert fuel injectors onto fuel collection pipe -2- and secure them using spring clamp.
2.4. Press fuel collection pipe -2- with fuel injectors 4-6 into the mountings in the intake-air distributor.
2.5. Fit and tighten M6 screws -13-.
Tightening torque: 10 Nm (7.5 ftlb.)
3. Fit fuel lines.