911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Attach line to both holders, close holders and secure with fastening screws.
3. Engage air guide on condenser -A- and screw down using the two fastening screws -1-. - Tightening torque: 4 Nm (3 ftlb.)
Subsequent work
Subsequent work for line condenser-condenser
Filling in refrigerant.
Install front apron.
Removing and Installing Compressor-Condenser Line At Front
Removing And Installing Compressor-condenser Line At Front
Technical values
Preliminary work
Preliminary work on compressor-condenser line
-
Remove front right wheel.
-
Remove front right wheel housing liner.
-
Drain refrigerant.
Removing compressor-condenser line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.