911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Insert compressor-condenser line into the line to the compressor and fasten with the fastening screw -2-. - Tightening torque: 14 Nm (10.5 ftlb.)
3. Close and engage holder for rubber mounting.
4. Insert compressor-condensor line into the condenser and fasten it with the fastening screw -1-. - Tightening torque: 14 Nm (10.5 ftlb.)
Subsequent work
Subsequent work on compressor-condenser line
Fill in refrigerant.
Install front right wheel housing liner.
Install front right wheel.
Removing and Installing Compressor-Condenser Line In Area of Engine
Removing And Installing Compressor-condenser Line In Area Of Engine
Technical values
Preliminary work
Preliminary work on compressor-condenser line
Drain refrigerant.
Remove drive belt
Unscrew compressor from engine block.
Removing compressor-condenser line
INFORMATION:
-
Close off all lines and connections using suitable plugs during removal.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.