911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Position the instrument cluster, connect the electrical plug and lock.
2. The instrument cluster has two retaining clips; push instrument cluster into the dashboard and press on until the retaining clips engage.
3. Screw down instrument cluster with both fastening screws -1-. - 4.2x16-C: 2.3 Nm (2.0 ftlb.)
4. If a new instrument cluster was installed
Subsequent work
Reworking instrument cluster
Install top steering-column panel.
Programming instrument cluster
Reading and printing values
INFORMATION:
-
If the instrument cluster is replaced or exchanged, the instrument cluster must be programmed and coded using the PIWIS Tester 9718. This is
done to adapt the instrument cluster to the vehicle and equipment.
-
If possible, before the instrument cluster is removed and replaced, a read-out of the vehicle data should be obtained using the Porsche System
Tester.
-
During coding, it is essential to guarantee the power supply for the Porsche System Tester. It is essential to connect a battery charger with a current
rating of at least 40 A to the vehicle battery.
-
The Porsche System Tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed.
Deviations may occur with later software versions.
-
The procedure described here has been structured in general terms; different text or additions may appear in the Porsche System Tester.
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on ignition. >> Continue.
2. Select vehicle type >>.
3. Switch from the vehicle type to the list of control units.
4. Select Instrument cluster and press the >> key.
5. Select Control unit replacement with the cursor keys and press the >> key.
6. Select Read out values (codings) with the cursor keys and press the >> key.
7. The message Coding read-out complete will appear on the screen of the Porsche System Tester. Press the >> key.
8. Switch off ignition and replace instrument cluster.
9. Switch on ignition. After replacement of the control unit, the vehicle data is installed under the menu Write in data >>.
10. System Tester displays Coding write-in complete. Press the >> key.