911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
If a new control unit has to be installed, read out as much of the data from the old control unit as possible using the PIWIS tester 9718.
WARNING:
Risk of damage to electronic control modules.
-
If care is not taken, electrical and electronic components may be destroyed.
-
Before removing the control module, switch off the ignition and remove the ignition key.
1. Unscrew fastening screw -3-.
2. Push a screwdriver into the openings -A- and unclip the four clips holding the cover -1-.
3. Release and unplug both electric connectors -A- and disengage the left and right electric lines on the control unit.