911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
3. Unscrew fastening screw -3- for angle sensor retaining bracket on side member from below.
4. Remove angle sensor from retaining bracket.
Installing front angle sensor for headlight levelling system
INFORMATION: If the angle sensor has been replaced, the front end control unit must be calibrated; afterwards the headlight setting must be
checked and adjusted if necessary.
1. Fasten angle sensor to retaining bracket and secure with fastening screw -3- to the side member.
2. Engage electrical plug connection and pull rubber cover -1- carefully over the plug connection (protects against ingress of water).
3. Engage intermediate link on rotary lever and secure with fastening nut -2-. - Tightening torque: 7 Nm (5 ftlb.)
Subsequent work
Subsequent work - front angle sensor for headlight levelling system
INFORMATION: If the angle sensor has been replaced, the front end control unit must be calibrated; afterwards the headlight setting must be
checked and adjusted if necessary.
1. Install front underbody panel.