911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Fuel Filter: Service and Repair
Removing And Installing Fine Fuel Filter
Removing fuel filter
DANGER:
Risk of fire from escaping fuel.
-
Danger of fatal injury and damage to property.
-
Observe basic safety instructions when working on the fuel system.
-
Secure working area.
1. Remove air cleaner housing.
2. Reduce fuel pump supply pressure. To do this, remove the cover of the fuse carrier in the left footwell and take out the fuses for the fuel pump -
level D, fuses F1 and F2 (1st and 2nd from left). Then start the engine for about 10 seconds. This procedure does not cause an entry to be made in
the fault memory. Insert the fuse again and replace the cover.
3. Unclip fuel lines at the plastic holder on the fuel filter and loosen plug connections for fuel -1 and 3- and the ground strap -4-. Absorb emerging
fuel with a cloth.
4. Carefully release the locking clip on the filter holder -1- by moving it towards the rear end and at the same time pull the filter module out of the
groove on the coolant reservoir -Arrow-.