911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
INFORMATION: When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
1. Unscrew the fastening screw -1- for the condenser line and pull the line out of the condenser.
2. Unclip holder for line and remove the line.
3. Unscrew the fastening screw -2- for the line to the compressor and pull the line out of the compressor line.
4. Pull the line out of the line holder and take it out.
Installing compressor-condenser line
INFORMATION: When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
1. Clip line into the line holder at the top and engage it in the rubber mounting.
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.