porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 2885 > < Procedures|Page 2883
Page 4
background image

9. Unclip wire harness to loudspeaker amplifier -Arrows A- and remove adhesive tape -Arrow B-.

10. Unclip wire harness to CD changer/navigation unit -arrows-.
11. Remove grommets -16- left and right.
12. Pull through main wire harness in direction of plenum panel.
13. Disconnect and release ABS wire harness front left and right -17 and 18-.

13.1. Release and disconnect plug connection for wheel sensor at left and right.
13.2. Unscrew fastening screw of connector socket.
13.3. Release rear wire harness.

14. Release and pull off connectors on front antenna for tyre pressure monitoring system -19 and 20- at left and right.
15. Release and pull off connector of switching element for filler flap -21-
16. Pull off connector from tank filler neck -22-.

INFORMATION:  Only in the cabriolet.

17. Release connector on rod antenna -23- and pull it off.

18. Unclip wire harness on end plate under windscreen at the three retaining clips -arrow-.
19. Release connector on GPS antenna -24- and pull it off.
20. Release connector on radio antenna -25- and pull it off.
21. Release connector for vertical sensor -26- and pull it off.
22. Release connector for pressure switch -27- and pull it off.

INFORMATION:  Only for vehicles with I number 536

23. Release connector for alarm siren -28- and pull it off.
24. Release and pull off B+ line -29- from power distributor.

Procedures|Page 2885 > < Procedures|Page 2883