911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Remove B+ line from power distributor to transmission connection point
1. Unclip B+ line -3- from heater/air-conditioning unit.
1.1. Unclip B+ line at tie-wrap from heater/air-conditioning unit.
1.2. Disconnect B+ line from main wire harness. To do this, remove the tie-wrap and the binding band.
2. Unclip B+ line -3- at unit carrier.
2.1. Unclip B+ line at retaining clip -arrow- from unit carrier.
2.2. Pull B+ line through unit carrier.
3. Loosen B+ lead -3- at centre tunnel.
3.1. Pull B+ line out of the two holders -arrows-.
3.2. Push B+ line under the carpet away from the direction of travel.