911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Push the wire harness for the front-end through the openings in the body and fit the three grommets -21-.
3. Fasten wire harness for the front-end with the holders -24- to the body.
4. Push together plug connection for front-end wire harness to main wire harness, left -20- until it engages securely.
5. Push connector onto servo motor for front lid -19-.
5.1. Push connector onto servo motor for front lid until it engages securely.
6. Push together plug connection on microswitch for lower part of front lid lock -18- until it engages securely.
7. Clip in front-end wire harness on right side at tie-wraps -22-.
8. Push connector onto control unit for garage door opener/HomeLink -17- until it engages securely.
9. Push connector onto servo motor for front lid release -16- until it engages securely.
10. Push connectors onto the two horns -14 and 15- until they click into place.
11. Push connector onto outside temperature sensor -13- until it engages securely.
INFORMATION: Only for USA/Canada version vehicles
12. Push connector onto front emergency release -12- until it engages securely.
13. Clip in front-end wire harness on left side at holder -23-.
14. Clip in front-end wire harness on right side at tie-wraps -22-.
15. Push connectors onto both sensors for front airbag -11- until they engage securely.
16. Clip in cable guide for sensor line for front airbag -10-.
17. Push connector and plug connection onto control unit for coolant control -7 to 9-.
17.1 Push the two connectors onto the control unit for coolant control -8 and 9- until they engage securely.
17.2. Push on plug connection to coolant fan -7- until it engages securely.
18. Push connector onto headlight -5- at the left and right.
18.1. Push connector onto headlight at left and right -arrow A-.
18.2. Push on securing clip from below until it engages securely -arrow B-.