911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Intake Air Duct: Service and Repair
Removing And Installing Pressure Pipe
Information
Overview
Removing pressure pipe
1. Remove pressure pipe.
1.1. Pull off cable plug on pressure sensor -3-.
1.2. Loosen screw-type clamps -6- and pull hoses off the charge air cooler on the pressure pipe.
1.3. Loosen screw-type clamp -2- on throttle housing and pull pressure pipe out of the rubber mountings and remove it.
2. Remove air cowl.
Loosen screw-type clamp and pull air cowl off the throttle housing.
Installing pressure pipe
1. Pre-fit air cowl on pressure pipe.
Position air cowl on pressure pipe and secure with a screw-type clamp.
2. Install pressure pipe.