911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Throttle Body: Service and Repair
Removing And Installing Throttle Housing
Technical values
Preliminary work
1. Remove pressure pipe.
2. Remove air cleaner housing.
Removing throttle housing
1. Remove throttle housing.
1.1. Disconnect cable plug on throttle potentiometer and unclip cable.
1.2. Unscrew holder for throttle housing.
Screw off M6 nut on rubber mountings.
1.3. Unscrew screws -arrows- and remove throttle housing.
Installing throttle housing
1. Replace seal on central intake-air distributor.
INFORMATION: Always replace seal between the intake-air distributor and throttle housing.
2. Install throttle housing.
2.1. Fit throttle housing and screw in and tighten screws -arrows-.
Pre-fit holder on throttle housing.