911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
23. Plug new line into the contact strip until the contact is felt to engage.
24. Push connector guide onto the connector until it is felt to engage.
25. Push connector housing onto the connector
25.1. Before fitting the connector housing, check for signs of damage, and replace if necessary.
25.2. Push connector housing onto the connector until it is felt to engage.
26. Fasten wire harness with a new tie-wrap -arrow- to the connector housing.
27. Insert seal into the connector.
27.1. Before inserting the seal, check for signs of damage, and replace if necessary.
27.2. Insert seal into the connector and press down as far as it will go. Check seal is seated properly.
28. Push on connector of triggering unit for airbag -10- until it is felt to engage, and lock it.
Installing wire harness for airbag from the A-pillar connection point to the head airbag
WARNING:
Incorrect handling of airbag units
-
Triggering of airbag unit
-
System faults can occur
-
Switch off ignition and remove ignition key.