911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
7. If required, install control unit for tilt sensor.
8. Connect battery.
9. Install centre console.
10. Install centre console cover.
11. Install cover of console at the left and right.
Subsequent work for wire harness for right seat-belt tensioner
1. Install support under the sill.
2. Install sill.
3. Install the rear side-panel lining.
4. Install front seat.
5. Install front side section trim.
6. Install glove compartment.
7. If required, install control unit for tilt sensor.
8. Connect the battery.
9. Install centre console.
10. Install centre console cover.
11. Install cover of console at the left and right.
Subsequent work for wire harness for left head airbag (triggering unit to A-pillar connection point)
1. Install front side section trim.
2. Install trim panel under dashboard on the left.
3. If required, install control unit for tilt sensor.
4. Connect the battery.
5. Install centre console.
6. Install centre console cover.
7. Install cover of console at the left and right.
Subsequent work for wire harness for right head airbag (triggering unit to A-pillar connection point)
1. Install front side section trim.
2. Install glove compartment.
3. If required, install control unit for tilt sensor.
4. Connect the battery.
5. Install centre console.
6. Install centre console cover.
7. Install cover of console at the left and right.
Subsequent work for head airbag wire harness (head airbag to A-pillar connection point)
1. Install door trim panel.
2. Install front side section trim.
Removing and Installing Driver's Airbag Unit
Removing And Installing Driver's Airbag Unit
Preliminary work for driver's airbag unit
INFORMATION: Operate the steering wheel with the battery disconnected. Before disconnecting the battery, observe the following points:
1. Insert ignition key into ignition lock, switch on ignition and then off again.
2. Leave ignition key inserted.
3. Disconnect battery.
General warning notes
General warnings for driver's airbag unit
WARNING: Incorrect triggering of airbag module.
-
Danger of injury and damage to property as a result of incorrect handling of airbag units.
-
The safety regulations. Refer to Safety regulations for handling airbag and belt tensioner units must be followed.
-
The airbag unit must always be stowed so that the airbag opening faces upwards.
-
If removed for an extended period, the airbag unit must be kept in a locked place.
-
Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat
frame) is avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
CAUTION: Incorrect release of airbag unit.