911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
-
Ignition and preparations may only be carried out by skilled staff, supervised by a second responsible person.
-
Before disposal, the airbag unit must be rendered harmless by electrical ignition performed in accordance with all precautionary measures,
thereby preventing it from being used incorrectly.
CAUTION: Loosen the safety-related screw connection.
-
Danger of injury and material damage if the airbag module is screwed on incorrectly.
-
Always replace fastening screws for the airbag unit after customer service and reworking.
-
It is not permissible to make alterations to the microencapsulated screws (e.g., use lubricant, loosen bolts, and screw them down
again).
1. Unscrew the four fastening screws -2- for the airbag unit and carefully slide the airbag unit back a few centimetres, then remove it by pulling it
downwards.
2. Unclip the electric lines -4- to the left and right of the airbag unit.
3. Carefully prise out the locking unit -5- and -6- the electric connectors to the left and right with a screwdriver -a- and then pull the connectors out of
the airbag unit.
4. Remove airbag unit and lay it to one side in the appropriate manner.
Installing passenger's airbag unit
INFORMATION: If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will be
supplied with a barcode sticker (tear-off label).