911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
-
Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is
avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. Lift up the appropriate detached side bolster and undo the two fastening screws -1- from the airbag unit.
2. Pull the side airbag out from the backrest frame.
3. Undo and remove the fastening nut -2-.
4. Unlock the electric connector for the side airbag -3- and remove it -A-.
Installing side airbag
INFORMATION: If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will be
supplied with a barcode sticker (tear-off label).
-
Tear off the tear-off label -2- on the new component -1- and stick it under the heading Proof of airbag system check/component replacement in the
Guarantee and Maintenance booklet.