911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Clockspring Assembly / Spiral Cable: Service and Repair
Removing And Installing Contact Unit
Tools
Preliminary work
Preliminary work for contact unit
Remove driver's airbag unit.
Remove steering wheel. Refer to Removing and installing steering wheel.
Remove steering column trim. Refer to Removing and installing steering wheel.
Remove and disassemble steering column switch.
General warning notes
General warnings for contact unit
CAUTION: Danger of injury and material damage if airbag units are not handled correctly.
-
Incorrect triggering of airbag unit.
-
Always observe the safety regulations for handling airbag units.
WARNING: If the contact unit has been adjusted, proceed in accordance with the following work instruction:
-
Damage to the contact unit.
-
To position the airbag contact unit in the central position, press the locking element and turn the rotor carefully to the left as far as it
will go.
-
Then turn the rotor carefully to the right, approx. 3.5 to 3.75 revolutions, until the band printed on one side is visible in the window.
Removing contact unit for airbag
INFORMATION: Ensure that arrow -A- of the rotor is positioned between the markings -B- of the arrows -C- of the airbag contact unit and that the
locking element -D- is engaged.