911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
-
If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will be supplied with
a barcode sticker (tear-off label).
-
Tear off the tear-off label -2- on the new component -1- and stick it under the heading Proof of airbag system check/component replacement in the
Guarantee and Maintenance booklet.
-
Tear off the tear-off label -2- on the new component -1- and stick it under the heading Proof of airbag system check/component replacement in the
Guarantee and Maintenance booklet.
Component exchange after airbag/belt tensioner triggering
The following components must be removed and replaced after the airbag system is triggered:
Airbag unit, driver's side:
1. Contact unit.
2. Airbag unit, driver's side.
3. Triggering unit after the third time the airbag is triggered.
Airbag unit, passenger's side:
1. Airbag unit, passenger's side.
2. Triggering unit after the third time the airbag is triggered.
3. Instrument panel.
4. Check instrument panel bracket for deformation and replace if necessary.
Side-airbag unit, seat:
1. Side-airbag unit, seat.
6. Seat covering, deformed seat components.
7. Sensor for the side-airbag unit after the third time the side-airbag is triggered
Head airbag unit, door:
1. Head airbag unit.
9. Check door unit carrier for deformation and replace if necessary.
10. Sensor for the side-airbag unit after the third time the side-airbag is triggered
Belt tensioner:
1. All belt tensioner units.
Because it is difficult to visually determine if one or more belt tensioners has been triggered, check the following points:
-
Using the PIWIS Tester 9718, read out the fault memory.