911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
/f6-3.6l_turbo/Page-28001.png)
Convertible Top Position Sensor / Switch: Service and Repair
Removing and Installing Potentiometer
Removing And Installing Potentiometer
Tools
Preliminary work
Preliminary work for potentiometer
1. Open convertible top.
2. Remove rear left side-panel lining and remove hydraulic cylinder. Refer to Removing and installing convertible top
3. Convertible top service position, Refer to Convertible top service position
Removing potentiometer
1. Loosen the two fastening screws -arrow- and remove the potentiometer.
2. Unclip the potentiometer lines downwards and disconnect the electric plug connection (connection point X 26).
3. Carefully remove insulating tape from the potentiometer to the plug connection without damaging any other wires. Expose the potentiometer lines
(green, yellow and red).
4. Unlock both sides by inserting a small screwdriver and shift in the direction of the arrow. The figure -inset- shows the secondary locking unlocked.
