911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Oil Pressure Sender: Service and Repair
Removing and installing oil-pressure sender
Information
Overview
Oil-pressure sender (view for turbo engine)
1 - Oil-pressure sender
2 - Torx screws, M6 x 20
3 - Intake air line, 4-6
Preliminary Work
1. Remove pressure pipe.
2. Remove throttle housing.
3. Remove air conditioning compressor (without opening the air-conditioning system). Place compressor on a base in the engine compartment and
secure using tie-wrap.
Removing oil-pressure sender
1. Remove oil-pressure sender.
1.1.
Pull off cable plug from sender.
1.2.
Unscrew Torx screws (M6 x 20) and remove oil-pressure sender -1-.
The screws are accessible via the intake-air distributor on side 4-6.