911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Connect connector to the AWS control unit -arrow- until the connector engages securely.
3. Secure wire harness for AWS.
3.1. Secure wire harness for AWS to the seat shell using new tie-wraps -1-.
3.2. Secure wire harness for AWS to the seat frame at the left and right using new tie-wraps -1-.
4. Install cover for AWS sensors at the left and right.
4.1. Position cover for AWS sensors -2- on the seat rail.
4.2. Tighten three fastening screws -1-. - Tightening torque: 4 Nm (3 ftlb.).
Subsequent work
1. Install the front seat.
2. Connect the battery
Removing and Installing Wiring Harness For Centre Console
Removing And Installing Wiring Harness For Centre Console
Preliminary work
Preliminary work for interior monitoring sensor