911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Place socket in installation position -arrow A- and screw on the fastening nut. - Tightening torque: 10 Nm (7.5 ftlb.)
2. Plug in the two connectors -arrow B-.
3. Fold back the cable retainer -arrow C- until it engages correctly at the connectors.
4. Press the ABS wire harness into the supports by pressing on the rubber sleeves -arrows-.
5. Push the ABS wire harness inward -arrow-.
INFORMATION: Only for vehicles with TPM.
6. Cut through the rubber sleeve -a- and insert the HBA line -arrow A-. Stick the rubber sleeve together at the cut edge -a- using a commercially
available PUR adhesive and seal. Press the rubber seal into the opening -arrow B-.
INFORMATION:
-
Select a place for the joint where there is enough space to join all the lines present.
-
Do not cut the lines too short in case they have to be laid in a different position if there is insufficient space in the area of the joint.
-
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
-
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The
procedures are described in detail in the repair kit for harnesses NR.155-1.
-
Crimping samples are to be prepared before beginning work.
7. Crimp lines in area around -b-.