911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
electronics unit.
3. Fitting lower tire bead (first tire bead).
Place the tire at the correct position on the disc wheel (check direction of rotation and inside/outside position).
Push in mounting arm and position on top of the rim flange. The mounting head must be offset by 180° with respect to the valve.
Mounting tire, lower bead, Figure 1
Push the lower tire bead (first tire bead) partly over the rim flange and guide it through the mounting head. Turn the disc wheel slowly in a
clockwise direction (clockwise rotation of mounting table) until the lower tire bead is completely fitted.
Mounting tire, lower tire bead, Figure 2
4. Fitting upper tire bead (second tire bead) using bead holding-down device.
This presses the tire bead into the deep bed.
Information
^
Always use a bead holding-down device for mounting the upper tire bead (second tire bead).
^
There are two types of bead holding-down devices. These are described in sections 4.1 and 4.2 below.
^
Use the Wulstboy bead holding-down device (type 2 in section 4.2) for tire/wheel combinations that are difficult to mount.
4.1.
Fitting upper tire bead (second tire bead) using bead holding-down device type 1 = special tool 9539
Position the mounting head -1- approx. 15 cm to the right of the valve -2-.